Kia Forte: Control Cable Installation - Manual Transaxle Control System - Manual Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Control Cable Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Cable Installation

  
When installing, set room side Shift lever and T/M side lever to N position.
1.
Install the control cable (B) and clip (A) on the bracket.

2.
Install the washer (B) and pin (A).

3.
Tighten the nut (B) after install the retainer (A).

Tightening torque:
11.8 ~ 14.7 N.m (1.2 ~ 1.5 kgf.m, 8.7 ~ 10.8 lb-ft)

4.
Install the cable socket (A) on the shift lever assembly.

5.
Install the shift cable (B) and clip (A).

6.
Shift lever to "3rd".
7.
Install the snap pin (A) after install the select cable (B).
  
Install the snap pin (A) after adjust the select cable (B).
(Refer to Control Cable - "Adjustment")

8.
Install the floor console assembly.
(Refer to Body - " Floor Console")
9.
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
10.
Install the air cleaner assembly.
(Refer to Engine Electrical System - "Battery")
Control Cable Removal
1. Remove the floor console assembly. (Refer to Body - " Floor Console") 2. Remove the select cable (B) by removing the snap ...

Control Cable Adjustment
Select cable adjustment 1. Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin. 2. ...

See also:

Smart Key Unit Circuit Diagram
...

SS-A Solenoid Valve(ON/OFF) Inspection
1. Turn ignition switch OFF. 2. Disconnect the Solenoid valve connector. 3. Measure resistance between sensor ...

Torque Converter Control Solenoid Valve (T/CON_VFS) Removal
1. Disconnect the negative (-) battery cable. 2. Remove the air cleaner assembly and air duct. (Refer to Engine Mechanical System - &qu ...

Copyright © www.kifomanual.com 2014-2024