Kia Forte: Control Cable Adjustment - Manual Transaxle Control System - Manual Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Control Cable Adjustment

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Control Cable Adjustment

Select cable adjustment
1.
Remove the select cable snap pin (A) and then remove the select cable (B) from the shift lever pin.

2.
Shift the shift lever to 3rd gear.
3.
Move the slide clip (B) of guide member (A) in the direction as shown in the illustration.

4.
Install the select cable (A).

5.
Insert the slide clip in the direction as shown in the illustration and then install the snap pin (A).

Control Cable Installation
   • When installing, set room side Shift lever and T/M side lever to N position. ...

Control Shaft Complete Description
Component location : Control shaft assembly is mounted on the top of the manual transaxle Function : Change the gear by shifting a shift lever. ...

See also:

Piston and Connecting Rod Inspection
Connecting Rod 1. Check the connecting rod side clearance. Using a feeler gauge, measure the end play while moving the connecting rod back and forth. ...

Front Stabilizer Bar Replacement
1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A ...

Installation
1. Install in the reverse order of removal. 2. Adjust the ignition lock switch. (1) In state of full stro ...

Copyright © www.kifomanual.com 2014-2025