Kia Forte: Cylinder Head Components
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cylinder Head Assembly / Cylinder Head Components
| 1. Camshaft bearing cap 2. Camshaft front bearing cap 3. Exhaust camshaft 4. Intake camshaft 5. Exhaust CVVT assembly 6. Intake CVVT assembly |
7. Cam carrier 8. Cylinder head 9. Cylinder head gasket 10. Retainer lock 11. Retainer 12. Valve spring |
13. Valve stem seal 14. Valve 15. Swing arm 16. Hydraulic lash adjuster (HLA) |
CVVT & Camshaft Installation
1.
Install the CVVT assembly (A) to the camshaft.
Tightening torque :
64.7 ~ 76.5 N.m (6.6 ~ 7.8 kgf.m, 47.7 ~ 56.4 lb-ft)
...
Cylinder Head Removal
Engine removal is not required for this procedure.
•
Use fender covers to avoid damaging pa ...
See also:
Center Pillar Trim Replacement
[Center pillar lower trim]
(4Door, 5Door)
•
Put on gloves to protect your hand ...
Rear Shelf Side Trim Component Location
(5Door)
1. Rear shelf side trim
...
In-car Sensor (DATC only) Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the center fascia panel.
(Refer to Body - "Center Fascia Panel")
...
Copyright © www.kifomanual.com 2014-2025