1. |
Turn the ignition switch OFF.
|
2. |
Disconnect evaporator temperature sensor.
|
3. |
Using the multi-tester, measure resistance between terminal "1"
and "2" of the evaporator temperature sensor.
|
4. |
Connect the evaporator temperature sensor connector.
|
5. |
Run the engine and turn the A/C switch ON, then measure the voltage
between the terminals of the harness connector.
Specification
|
Removal
1.
Remove the transaxle assembly.
(Refer to Manual Transaxle System - " Manual Transaxle")
2.
Remove the clutch release beari ...
Telemetics Unit (TMU) Inspection
1.
After replacing the TMU unit, access Dealer Engineering Mode in
head unit.
(Refer to MTS system - "TMU Dealer Engineering Mode")
2 ...
Crankshaft Damper Pulley Removal and Installation
1.
Remove the RH front wheel.
2.
Remove the drive belt.
(Refer to Timing System - "Drive Belt")
3.
...