(4Door, 5Door) |
|
1. |
Remove the center pillar upper trim.
(Refer to Interior Trim - "Center Pillar Trim")
|
2. |
After loosening the mounting bolt, then remove the front seat
belt upper anchor (A).
|
3. |
After disconnecting the pretensioner connector lock pin, remove
the front seat belt pretensioner connector (A), loosen the mounting
bolt, then remove the front seat belt pretensioner (B).
|
4. |
Install in the reverse order of removal.
|
Variable Charge Motion Actuator (VCMA) Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the VCMA connector.
3.
Check that the VCMA is not stuck by foreign ...
Alternator Installation
1.
Install in the reverse order of removal.
2.
Adjust the alternator belt tension after installation.
(Refer to Engine Mechanical ...
Accelerator Position Sensor (APS) Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Turn the ignition switch ON.
3.
Measure the output volt ...