Kia Forte: Temperature Control Actuator Description

The heater unit includes mode control actuator and temperature control actuator.

The temperature control actuator is located at the heater unit. It regulates the temperature by the procedure as follows.

Signal from control unit adjusts the position of the temperature door by operating the temperature switch. Then the temperature will be regulated by the hot/cold air ratio decided by the position of the temperature door.

Evaporator Core Replacement

1. Disconnect the negative (-) battery terminal. 2. Remove the heater and blower assembly. (Refer to Heater -"Heater Unit") ...

Temperature Control Actuator Inspection

1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the t ...

See also:

Starter Removal
1. Disconnect the battery negative terminal. 2. Remove the air duct and air cleaner assembly. (Refer to Engine Mechanical System - &quo ...

Removal
1. Separate the push rod (C) after remove the pin (A) and washer (B). 2. Remove the battery. (Refer to Engine Electrical S ...

ECM Terminal And Input/Output signal (M/T)
ECM Terminal Function Connector [CNG-MA] Pin No. Description Connected to 1 Ignition Coil (Cylinder #1) control output Ignition Co ...