Kia Forte: Cylinder Head Components

CVVT & Camshaft Installation

1. Install the CVVT assembly (A) to the camshaft. Tightening torque : 64.7 ~ 76.5 N.m (6.6 ~ 7.8 kgf.m, 47.7 ~ 56.4 lb-ft) ...

Cylinder Head Removal

Engine removal is not required for this procedure.    • Use fender covers to avoid damaging ...

See also:

Troubleshooting
Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel b ...

Audio system
✽ NOTICE If you install an after market HID head lamp, your vehicle’s audio and electronic device may malfunction. Glass antenna (if equipped) When the radio power switch is turned on ...

Oil Pressure Switch Removal and Installation
1. Disconnect the oil pressure switch connector (A) and then remove the oil pressure switch (B). Tightening torque : 9.8 ~ 11.8N.m (1 ...