Kia Forte: Water pump Removal and Installation
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Water pump Removal and Installation
| 1. |
Loosen the drain plug, and then drain the engine coolant. Remove
the radiator cap to help drain the coolant faster.
|
| 2. |
Remove the drive belt.
(Refer to Timing System – “Drive Belt”)
|
| 3. |
Remove the water pump pulley (A).
|
| 4. |
Remove the water pump assembly (A) with the gasket (B).
|
| 5. |
Install in the reverse order of removal.
|
| 6. |
Fill the engine coolant.
|
| 7. |
Start the engine and check for leaks.
|
| 8. |
Recheck the coolant level.
|
Water pump Components
1. Water pump pulley
2. Water pump
3. Water pump gasket
...
Water pump Inspection
1.
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
2.
Check the bearing for damage, abnorm ...
See also:
Components
1. Driver Airbag (DAB)
2. Steering Wheel
3. Clock Spring
4. Seat Belt Pretensioner (BPT)
5. Pressure Side Impact Sensor (P-SIS)
6. Side Impact Sensor (SIS)
7. Side Airbag ...
DC/DC Converter Removal
1.
Disconnect the battery negative (-) cable.
2.
Remove the crash pad lower panel.
(Refer to Body - Crash pad lower panel.)
...
Starter Disassembly (NON-ISG Type)
1.
Disconnect the M-terminal (A) on the magnet switch assembly.
2.
After loosening the screws (A), detach the magnet switch ssembly
...
Copyright © www.kifomanual.com 2014-2024