Kia Forte: Water pump Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cooling System / Water pump Inspection
| 1. |
Check each part for cracks, damage or wear, and replace the coolant
pump assembly if necessary.
|
| 2. |
Check the bearing for damage, abnormal noise and sluggish rotation,
and replace the coolant pump assembly if necessary.
|
| 3. |
Check for coolant leakage. If coolant leaks from hole, the seal
is defective. Replace the coolant pump assembly.
|
Water pump Removal and Installation
1.
Loosen the drain plug, and then drain the engine coolant. Remove
the radiator cap to help drain the coolant faster.
2.
Remove the drive ...
Water pump Troubleshooting
Symptoms
Possible Causes
Remedy
Coolant leakage
•
From the bleed hole of the water pump
Visually ...
See also:
On-board Refueling Vapor Recovery (ORVR) valve Removal
1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Remove the fuel pump.
(Refer to Fuel System - "Fuel Pump&qu ...
Compressor Installation
1.
Make sure the compressor mounting bolt with the correct length
is screwed in. Tighten the mounting bolts (A) with the specified tightening
order.
...
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake/clutch* ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026