Kia Forte: Alternator Reassembly - Charging System - Engine Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Alternator Reassembly

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Electrical System / Charging System / Alternator Reassembly

1.
Reassemble in the reverse order of disassembly.
  
When reassembling OAD pulley, replace with new OAD cap.
Alternator Disassembly
1. Remove the rear cover (A) after removing nuts (B). 2. Remove the mounting bolts (A) and the regulator assembly (B). ...

Alternator  Inspection
[Rotor] 1. Check that there is continuity between the slip rings (C). 2. Check that there is no continuity between the slip ...

See also:

Starter Inspection
Starter Solenoid Inspection 1. Disconnect the lead wire from the M-terminal of solenoid switch. 2. Connect the battery as shown. If ...

IMS Power Seat Control Installation
   - Make sure that the IMS control switch connectors and related connectors are plugged in ...

Fuel Tank Air Filter Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Lift the vehicle. 3. Dis ...

Copyright © www.kifomanual.com 2014-2025