Kia Forte: Inspection
| 1. |
After disconnecting the vapor hose from the PCV valve, remove
the PCV valve.
|
| 2. |
Reconnect the PCV valve to the vapor hose.
|
| 3. |
Run the engine at idle, then put a finger over the open end of
the PCV valve and make sure that intake manifold vacuum can be felt.
|
| 4. |
If the vacuum is not felt inspect PCV operation, if operating
correctly clean or replace the vapor hose.
|
See also:
Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front d ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Front Cross Member
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
...
Copyright © www.kifomanual.com 2014-2024