Kia Forte: Engine Coolant Temperature Sensor (ECTS) Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS) Inspection
| 1. |
Turn the ignition switch OFF.
|
| 2. |
Disconnect the ECTS connector.
|
| 3. |
Remove the ECTS.
|
| 4. |
After immersing the thermistor of the sensor into engine coolant,
measure resistance between the ECTS terminals 1 and 3.
|
| 5. |
Check that the resistance is within the specification.
|
Engine Coolant Temperature Sensor (ECTS) Circuit Diagram
(M/T)
(A/T)
...
Engine Coolant Temperature Sensor (ECTS) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the engine coolant temperature sensor connecto ...
See also:
Shift Cable Installation
1.
Install in the reverse order of removal.
•
...
Control Cable Removal
1.
Remove the floor console assembly.
(Refer to Body - " Floor Console")
2.
Remove the select cable (B) by removing the snap ...
TJ Joint Installation
1.
Wrap tape around the driveshaft spline (TJ) to prevent damage
to the boot.
2.
Using the alignment marks (D) made during disassembly as a ...
Copyright © www.kifomanual.com 2014-2025