1. |
Disconnect the battery terminals (A).
|
2. |
Remove the air duct and air cleaner assembly. (Refer to Engine
Mechanical System - "Air Cleaner")
|
3. |
Remove the battery insulation pad.
|
4. |
Remove the battery (A) after removing the mounting bracket.
|
5. |
Remove the ECM.
(Refer to Engine Control/Fuel System - “Engine Control Module
(ECM)”)
|
6. |
Remove the battery tray (A) after removing the bolts.
|
Oil Pressure Switch Inspection
1.
Check the continuity between the terminal and the body with an
ohmmeter.
If there is no continuity, replace the oil pressure switch.
...
Engine And Transaxle Assembly Installation
Installation is in the reverse order of removal.
Perform the following :
•
Adjust shift cable.
•
Adjust throttle cable.
•
...
ETC (Electronic Throttle Control) System Inspection
Throttle Position Sensor (TPS)
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Start the engine and measure the output voltage of TP ...