Kia Forte: Accelerator Pedal Removal
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Fuel Delivery System / Accelerator Pedal Removal
| 1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
cable.
|
| 2. |
Disconnect the accelerator position sensor connector (A).
|
| 3. |
Remove the installation bolt (B), the nuts (C) and then remove
the accelerator pedal module.
|
Filler-Neck Assembly Installation
1.
Install in the reverse order of removal.
Filler-neck assembly bracket
installation bolt :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ...
Accelerator Pedal Installation
1.
Install in the reverse order of removal.
Accelerator pedal module installation
nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11. ...
See also:
Transaxle Oil Temperature Sensor Removal
1.
Disconnect the negative (-) battery cable.
2.
Remove the air cleaner assembly and air duct.
(Refer to Engine Mechanical System - &qu ...
Inspection
1.
Inspect diaphragm spring wear which is in contact with a clutch
release bearing.
2.
Check the clutch cover and disc surface for wear or ...
ECM Problem Inspection Procedure
1.
TEST ECM GROUND CIRCUIT: Measure resistance between ECM and chassis
ground using the backside of ECM harness connector as ECM side check
point. If the problem is fo ...
Copyright © www.kifomanual.com 2014-2024