Kia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Clutch System / Ignition Lock Switch / Installation

1.	Install in the reverse order of removal.

2.

Adjust the ignition lock switch.

(1)

In state of full stroke, adjust the gab by rotating the adjust nut (A) to satisfy the standard gap range.

Standard gap range :

3 ~ 4 mm (0.1181 ~ 0.1575 in.)

(2)

Tighten the nut (B) with the specified torque.

Tightening torque:

7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)

Removal

1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the smart junction box. (Refer to Body Electri ...

Clutch Pedal

...

See also:

Drive Belt Installation
1. Install the drive belt. (1) Install the drive belt (C). (2) Adjust the tension by t ...

Checking the washer fluid level
Check the fluid level in the washer fluid reservoir and add fluid if necessary. Plain water may be used if washer fluid is not available. However, use washer solvent with antifreeze characterist ...

Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the heater & A/C control unit. (Refer to Heating,Ventilation, Air Conditi ...

Categories

Copyright © www.kifomanual.com 2014-2026