Kia Forte: Adjustment
| Clutch Release Cylinder Air Bleeding Procedure |
|
| 1. |
After disconnecting a cap from the clutch release cylinder air
bleeder, insert a vinyl hose in the plug.
|
| 2. |
Refill the clutch master cylinder with the specified fluid.
|
| 3. |
Loosening the plug screw, press and release the clutch pedal about
10 times.
|
| 4. |
Tighten the plug (A) during the clutch pedal pressed. Afterwards,
raise the pedal with a hand.
|
| 5. |
After pressing the clutch pedal 3 times more, loosen the plug
(A) and re-tighten it with the pedal pressed. Raise it again, then.
|
| 6. |
Repeat the step 4 two or three times.
(until there is no bubble in the fluid)
|
| 7. |
Refill the clutch master cylinder with the specified fluid.
|
Installation
1.
Install in the reverse order of removal.
Apply the specified grease to ...
See also:
Starter Components
[NON-ISG Type]
1. Front bracket assembly
2. Magnet switch assembly
3. Lever
4. Reducer assembly
5. Lever stop
6. Gasket sheet
7. Yoke assembly
8. Armat ...
Scheduled maintenance service
Follow the Normal Maintenance Schedule if the vehicle is usually operated where
none of the following conditions apply. If any of the following conditions apply,
follow the Maintenance Under Severe ...
Checking the brake/clutch fluid level
Check the fluid level in the reservoir periodically. The fluid level should be
between MAX and MIN marks on the side of the reservoir.
Before removing the reservoir cap and adding brake/clutch* ...
Copyright © www.kifomanual.com 2014-2025