Kia Forte: Adjustment
| Concentric Slave Cylinder Air Bleeding Procedure |
| 1. |
After disconnecting a cap from the concentric slave cylinder air
bleeder, insert a vinyl hose in the plug.
|
| 2. |
Refill the reservoir tank with the specified fluid.
|
| 3. |
Pump the clutch pedal about 10 times.
|
| 4. |
Loosen the air bleed screw (A) at hold down the clutch pedal to
allow air to escape from the clutch system. Then tighten the air bleed
screw.
|
| 5. |
Repeat the step 2 ~ 4 until there is no bubble in the fluid.
|
Installation
•
Install the concentric slave cylinder bolts. Not to be
bent or twisted, Tighten them i ...
See also:
In-car Sensor (DATC only) Inspection
1.
Turn the ignition switch ON.
2.
Blow air with changing temperature into the in-car sensor air
inlet. Measure the sensor resistance betwe ...
Components
1. Parking brake lever
2. Parking brake cable
3. Equalizer assembly
...
Fluid Service Adjustment Procedure
Oil level Check
A check of Automatic Transaxle Fluid (ATF) level is not normally
required during scheduled ...
Copyright © www.kifomanual.com 2014-2024