1. |
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
|
2. |
Remove the front wheel and tire (A) from front hub.
|
3. |
Loosen the bolt & nut and then remove the lower arm (A).
|
4. |
Loosen the bolts and nuts and then remove the front lower arm
(A).
|
5. |
Installation is the reverse of removal.
|
6. |
Check the front alignment.
(Refer to Front Suspension System - "Front Alignment")
|
Variable Intake Solenoid (VIS) Valve Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the variable intake solenoid valve connector ( ...
Head Lamp Leveling Actuator Inspection with GDS
Initialization and diagnosis sequence by using GDS equipment.
Below content summarize the procedure for A/S using GDS.
No.
Procedure
1
Locate vehicle to flat ...
Output Speed Sensor Description
The output speed sensor is a vital unit that measures the rate of rotation
of the transaxle's turbine shaft and output shaft, and delivers the readings
to the Transaxle Control Module(TCM ...