1. |
Apply tire soap or lubrication to the top and bottom tire beads.
|
2. |
To fit the bottom bead, position the valve at the 5 o’clock position
relative to the head on the tire changing machine.
|
3. |
Place the tire on the rim so the bottom bead touches the edge
of the rim after the valve (6 o’clock). Rotate the rim clockwise, and
push down on the tire at the 3 o’clock position to fit bottom bead.
|
4. |
After bottom bead is on tire, rotate the rim until the valve is
at the 5 o’clock position relative to the head on the tire changing
machine. Push down on the tire at the 3 o’clock position and rotate
the rim clockwise to fit the top bead.
|
5. |
Inflate the tire until both beads seat.
|
Precautions
General Precautions
Please read the following precautions carefully before performing the
airbag system service.
Observe the instructions described in this manual, or the airba ...
Variable Charge Motion Actuator (VCMA) Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Disconnect the VCMA connector (A).
...
Oil Pump Unit (OPU) Inspection
OPU Problem Inspection Procedure
1.
TEST OPU GROUND CIRCUIT: Measure resistance between OPU and chassis
ground using the backside of OPU harness connector ...