Never attempt to measure the circuit resistance of the Seat Belt
Pretensioner (BPT) even if you are using the specified tester. If the
circuit resistance is measured with a tester, the pretensioner will
be ignited accidentally. This will result in serious personal injury.
|
Specifications
AVN Head Unit
Item
Specification
Power supply
DC 14.4V negative ground
Load Impedance
4ohm × 4
Tuning type
PLL SYNTH ...
Rear Hub - Carrier Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from ...
Fuel Pump Motor Removal
1.
Remove the fuel pump (Refer to “Fuel Pump” in this group).
2.
Disconnect the electric pump wiring connector (A) and the fuel
sender conn ...