Kia Forte: Removal
| 1. |
Disconnect the battery negative cable, and wait for at least thirty
seconds before beginning work.
|
| 2. |
Remove the seat belt after pushing the lock pin (A).
|
| 3. |
Remove the door scuff trim.
(Refer to Body - "Door scuff trim")
|
| 4. |
Remove the center pillar trim.
(Refer to Body - "Center pillar trim")
|
| 5. |
Remove the upper anchor bolt.
|
| 6. |
Loosen the seat belt pretensioner mounting bolts (B) and remove
the seat belt pretensioner.
|
| 7. |
Disconnect the seat belt pretensioner connector (A).
|
Components
...
Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty
seconds.
...
See also:
Windshield Wiper-Washer Switch Inspection
Check for continuity between the terminals while operating the wiper and
washer switch. If it is not normal condition, replace wiper and wiper switch.
Wiper Switch
Washer Switch
...
35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
Troubleshooting
•
The battery must be in good condition and fully charged
for this troubleshooting.
...
Copyright © www.kifomanual.com 2014-2025