Kia Forte: Removal - Brake Booster - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Brake Booster / Removal

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the battery (A) and ECM (B).

3.
Remove the master cylinder.
(Refer to Master Cylinder)
4.
Remove the snap pin (A) and clevis pin (B).

5.
Remove the mounting nuts (A).

Tightening torque:
16.7 ~ 25.5 N.m (1.7 ~ 2.6 kgf.m, 12.3 ~ 18.8 lb-ft)

6.
Disconnect the vacuum hose (A) from the brake booster.

7.
Remove the brake booster (B).
Brake Booster Operating Test
For simple checking of the brake booster operation, carry out the following tests. 1. Run the engine for one or two minutes, and then stop it. If the pedal depresses ...

Inspection
1. Inspect the check valve in the vacuum hose.    Do not remove the check va ...

See also:

Power Window Relay Inspection
Diagnosis With GDS 1. It will be able to diagnose defects of power window with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and ...

Purge Control Solenoid Valve (PCSV) Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Disconnect the purge control solenoid valve connector (A) ...

Heated Oxygen Sensor (HO2S) Circuit Diagram
(M/T) (A/T) ...

Copyright © www.kifomanual.com 2014-2025