1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
3. |
Remove the IMS module (B) after disconnecting the connector (A).
|
Rearview camera
The rear view camera will activate with the ignition switch on and the shift
lever in the R (Reverse) position.
Note- during initial start up, system may not display instantly due to the audio
...
Temperature Control Actuator Replacement
[Driver's side]
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body -& ...
Accelerator Position Sensor (APS) Installation
1.
Install in the reverse order of removal.
Accelerator pedal module installation
nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11. ...