Kia Optima Manuals

Kia Forte: Inhibitor Switch Inspection - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Inhibitor Switch Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Inspection

  
•
Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
Power Circuit Inspection
1.
Disconnect the Inhibitor swtich connector.
2.
Ignition KEY "ON"" & Engine "OFF".
3.
Measure voltge between supplied power and ground at inhibitor circuit.
Specification : Approx. 12V
Signal Circuit Inspection
1.
Connect the Inhibitor switch connector.
2.
Ignition KEY "ON" & Engine "OFF".
3.
Measure voltages between each terminal and chassis ground during shift lever changed "P, R, N, D".
Specification : See below "Signal Code Table"
Signal Code Table
　
 P
 P-R
 R
 R-N
 N
 N-D
 D
Signal "1"
 12V
 12V
 0
 0
 0
 0
 0
Signal "2"
 0
 12V
 12V
 12V
 0
 0
 0
Signal "3"
 0
 0
 0
 12V
 12V
 12V
 0
Signal "4"
 0
 0
 0
 0
 0
 12V
 12V

Inhibitor Switch Circuit Diagram
...

Inhibitor Switch Removal
1. Place the shift lever into the "N" position. 2. Remove the air cleaner. (Refer to Engine Mechanical System - "Air clea ...

See also:

Installation
1. Install in the reverse order of removal. 2. After be equipped, perform bleeding air procedure in clutch release cylinder after pouring t ...

Engine start/stop button
Illuminated ENGINE START/STOP button Whenever the front door is opened, the ENGINE START/STOP button will illuminate for your convenience. The light will go off after about 30 seconds after the ...

Steering wheel
Electric power steering (EPS) Power steering uses the motor to assist you in steering the vehicle. If the engine is off or if the power steering system becomes inoperative, the vehicle may still be ...

Categories

Copyright www.kifomanual.com 2014-2026