Kia Forte: Inhibitor Switch Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Inhibitor Switch Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Removal

1.
Place the shift lever into the "N" position.
2.
Remove the air cleaner.
(Refer to Engine Mechanical System - "Air cleaner")
3.
Remove the battery and the battery tray.
(Refer to Engine Electrical System - "Battery")
4.
Disconnect the inhibitor switch connector (A).
5.
Remove the shift cable mounting nut (B).

6.
Remove the manual control lever (B) and the washer after removing a nut (A).

7.
Remove the inhibitor switch (A) after removing the bolts (2ea).

Inhibitor Switch Inspection
   • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contam ...

Inhibitor Switch Installation
1. Check that the shift lever is placed in the "N" position 2. Install the inhibitor switch (A). ...

See also:

Adjustment
Clutch Release Cylinder Air Bleeding Procedure    • Use the specified fluid. Avoi ...

Components Location
1. Torsion beam axle 2. Shock absorber 3. Coil spring assembly ...

Engine Control Module (ECM) Installation
   When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. ...

Copyright © www.kifomanual.com 2014-2025