Kia Forte: Inhibitor Switch Installation - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Inhibitor Switch Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Inhibitor Switch Installation

1.
Check that the shift lever is placed in the "N" position
2.
Install the inhibitor switch (A).
  
Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.

3.
Install the manual control lever (A).
  
Lightly tighten the manual contorl lever nut (B) so that necessary adjustments can be made.

4.
Align the hole (A) in the manual control lever with the "N" position hole (B) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).

5.
Tighten the nut (A) and bolts (B) with the specified torque.

Tightening torque:
A : 7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.8 ~ 7.2 lb-ft)
B : 9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the SST (09480-A3800) from the hole.
7.
Connect the inhibitor switch connector (A).
8.
Install the shift cable by tightening nut (B).
  
Lightly tighten the shift cable mounting nut (B) so that necessary adjustments can be made.

9.
Push the shift cable to the arrow "F" to eliminate free play and then tighten the nut (A) with the specified torque.

Tightening torque:
9.8 ~ 14.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.8 lb-ft)

10.
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
11.
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
Inhibitor Switch Removal
1. Place the shift lever into the "N" position. 2. Remove the air cleaner. (Refer to Engine Mechanical System - "Air clea ...

Shift Lever Components
1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

See also:

Diagnosis procedure by using diagnostic device
As manual for diagnosis methods by using diagnosis device, the main contents are as follows: 1. Connect self-diagnosis connector(16pins) located in the lower of driv ...

Roof antenna Installation
1. Install the roof antenna. 2. Connect the roof antenna connectors. 3. Install the rear roof trim. ...

Electric Oil Pump Installation
1. Install in the reverse of removal. ...

Copyright © www.kifomanual.com 2014-2025