Kia Forte: Injector Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Control / Fuel System / Engine Control System / Injector Inspection

1.	Turn the ignition switch OFF.

2.	Disconnect the injector connector.

3.	Measure resistance between the injector terminals 1 and 2.

4.

Check that the resistance is within the specification.

Specification: Refer to “Specification”

Injector Circuit Diagram

(M/T) (A/T) ...

Injector Removal

1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line (Refer to the ...

See also:

Blower Resistor Inspection
1. Measure terminal-to-terminal resistance of the blower resistor. 2. If the measured resistance is not within specification, the blower re ...

Circuit Diagram
Hamess Connector Pin No. Discription Remark 1 - 2 - 3 - 4 ...

Troubleshooting
Symptom Suspect Area Remedy (Refer to page) Water leaks from sunroof Dirt accumulated in drain tube Clear dirt inside of drain Clogged drai ...

Categories

Copyright � www.kifomanual.com 2014-2026