Kia Forte: Inspection - Rear Drum Brake - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Inspection

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Rear Drum Brake / Inspection

  
Frequent inhalation of brake pad dust, regardless of material composition, could be hazardous to your health.
Avoid breathing dust particles.
Never use an air hose or brush to clean brake assemblies.
  
Contaminated brake linings or drums reduce stopping ability.
Block the front wheels before jacking up the rear of the vehicle.
1.
Raise the rear of the vehicle, and make sure it is securely supported.
2.
Release the parking brake, and remove the rear brake drum.
3.
Check the wheel cylinder (A) for leakage.

4.
Check the brake linings (B) for cracking, glazing, wear, and contamination.
5.
Measure the brake lining thickness (C). Measurement does not include brake shoe thickness.

Brake lining thickness
Standard: 4.5 mm (0.177 in)
Service limit: 1.0 mm (0.039 in)

6.
If the brake lining thickness is less than the service limit, replace the brake shoes as a set.
7.
Check the bearings in the hub unit for smooth operation. If it requires servicing, replace it.
8.
Measure the inside diameter of the brake drum with inside vernier calipers.

Drum inside diameter
Standard: 203.2 mm (8.0 in)
Service limit: 205.2 mm (8.079 in)
Drum roundness
Service limit: 0.06 mm (0.00236 in)

9.
If the inside diameter of the brake drum is more than the service limit, replace the brake drum.
10.
Check the brake drum for scoring, grooves, and cracks.
11.
Inspect the brake lining and drum for proper contact.

12.
Inspect the wheel cylinder outside for excessive wear and damage.
13.
Inspect the backing plate for wear or damage.
Installation
   • Do not spill brake fluid on the vehicle: it may damage the paint; if brake fluid does ...

Parking Brake System
...

See also:

Engine compartment
1. Engine oil filler cap 2. Engine oil dipstick 3. Brake/clutch fluid reservoir 4. Air cleaner 5. Fuse box 6. Positive battery terminal 7. Negative battery terminal 8. Windshield washer ...

Failure Diagnosis
1. In principle, ESC and TCS controls are prohibited in case of ABS failure. 2. When ESC or TCS fails, only the failed system control is pr ...

Starter Disassembly (NON-ISG Type)
1. Disconnect the M-terminal (A) on the magnet switch assembly. 2. After loosening the screws (A), detach the magnet switch ssembly ...

Copyright © www.kifomanual.com 2014-2024