Kia Forte: Removal - Brake Line - Brake System - Brake System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Brake System / Brake System / Brake Line / Removal

1.
Disconnect the brake fiuid level switch connector, and remove the reservoir cap.
2.
Remove the brake fluid from the master cylinder reservior with a syringe.
  
Do not spill brake fluid on the vehicle, it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
3.
Remove the wheel & tire.
4.
Disconnect the brake tube by loosening the tube flare nut (B).

Tightening torque:
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

Front

Rear

5.
Remove the brake hose clip (A).
6.
Disconnect the brake hose from the brake caliper by loosening the bolt (A).

Tightening torque:
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

Front

Rear

Brake Line
Components ...

Inspection
1. Check the brake tubes for cracks, crimps and corrosion. 2. Check the brake hoses for cracks, damage and fluid leakage. 3 ...

See also:

Battery Sensor Removal
1. Disconnect the battery negative (-) cable. 2. Disconnect the battery sensor connector (A). 3. Remove the bat ...

Removal
1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the seat belt after pushin ...

Canister Installation
1. Installation is the reverse of removal. Canister installation bolt/nut: 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m, 14.5 ~ 21.7 lb-ft) ...

Copyright © www.kifomanual.com 2014-2024