Kia Forte: Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn Relay Inspection
| 1. |
Remove the horn relay (A) from the engine room relay box.
|
| 2. |
There should be continuity between the No.30 and No.87 terminals
when power and ground are connected to the No.85 and No.86 terminals.
|
| 3. |
There should be no continuity between the No.30 and No.87 terminals
when power is disconnected.
|
Component Location
1. Horn switch
2. Horn relay (Engine room compartment)
3. Clock spring
4. Horn
...
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
...
See also:
Heater Unit Components
1. Heater Case (Left)
2. Heater Case (Right)
3. Console Separator
4. Defog Door
5. Vent Door
6. Floor Door
7. Mix Door (Manual)
8. Mix Door (DATC-Left)
9. Mix Door ( ...
Input Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Console Armrest Component Location
1. Console armrest
...
Copyright © www.kifomanual.com 2014-2025