Kia Forte: Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper cover.
(Refer to Body - "Front Bumper Cover")
|
| 3. |
Remove the bolt and disconnect the horn connectors, then remove
the horn (A).
|
Inspection
Test the horn by connecting battery voltage to the 1 terminal and ground
the 2 terminal.
The horn should make a sound. If the horn fails to make a sound, replace
it.
Horn Relay Inspec ...
Installation
1.
Install the horn and connect the horn connector.
2.
Reassemble the front bumper cover.
...
See also:
Replacement
1.
Remove the cap (A) and remove the nuts, then remove the wiper
arm (B).
Tightening torque :
22.6~26.5 N.m(2.3~2.7 kgf.m, 16.6~19.5 ...
Hands Free Switch Installation
1.
Reassemble the steering wheel remote control switch after connecting
the connector.
2.
Reassemble the driver airbag module.
...
35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
Copyright © www.kifomanual.com 2014-2025