Kia Optima Manuals

Kia Forte: Installation - Curtain Airbag (CAB) Module - Airbag Module - Restraint - Kia Forte TD 2014-2018 Service ManualKia Forte: Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module / Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least thirty seconds.
3.
Tighten the curtain airbag mounting bolts.
Tightening torque :
7.0 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
  
•
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim assembly.
(Refer to Body - "Roof trim assembly")
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
Removal
1. Disconnect the battery negative cable and wait for at least thirty seconds. before beginning work. 2. Remove the roof tr ...

Airbag Disposal
Special tool required Deployment tool 0957A-34100A Before scrapping any airbags or side airbags (including those in a whole vehicle to be scrapped), the airbags or side airbags ...

See also:

Shift Lever Removal
1. Remove the floor console assembly. (Refer to Body - "Floor Console") 2. Remove the air duct. 3. ...

Rear Door Module Component Location
(4Door, 5Door) 1. Rear door module ...

Windshield defrosting and defogging
WARNING - Windshield heating Do not use the or  position during cooling operation in extremely humid weather to reduce the likelyhood of fog up. For maximum defrosting, set the tempe ...

Categories


Copyright © www.kifomanual.com 2014-2025