Kia Forte: Removal - Ignition Switch Assembly - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Ignition Switch Assembly / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Low Panal")
3.
Remove the steering column upper and lower shrouds.
(Refer to Body - "Steering Column Shroud Panel")
4.
Remove the wiper switch.
(Refer to "Multifunction switch")
5.
Remove the ignition switch after disconnecting the ignition switch 6P connector.
6.
Remove the key warning/immobilizer connector (A).

7.
After loosening the screw, remove the key warning switch and key Illumination (B).
8.
Pushing lock pin with key ACC.
9.
Remove the key lock cylinder (A).

Ignition Switch Assembly
...

Installation
1. Install the key lock cylinder. 2. Install the key warning switch and key Illumination. 3. Install the key wa ...

See also:

Roof antenna Components
...

Battery Cleaning
1. Make sure the ignition switch and all accessories are in the OFF position. 2. Disconnect the battery cables (negative first). ...

Maintenance service
You should exercise the utmost care to prevent damage to your vehicle and injury to yourself whenever performing any maintenance or inspection procedures. Should you have any doubts concerning the i ...

Copyright © www.kifomanual.com 2014-2025