Kia Forte: Mode Control Actuator Description - Heater - Heating,Ventilation, Air Conditioning - Kia Forte TD 2014-2018 Service ManualKia Forte: Mode Control Actuator Description

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Heating,Ventilation, Air Conditioning / Heater / Mode Control Actuator Description

The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control actuator based on the signal of the A/C control unit. Pressing the mode select switch makes the mode control actuator shift in order of Vent → Bi-Level → Floor → Mix.
Temperature Control Actuator Replacement
[Driver's side] 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. (Refer to Body -& ...

Mode Control Actuator Inspection
1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode con ...

See also:

Adjustment
Concentric Slave Cylinder Air Bleeding Procedure 1. After disconnecting a cap from the concentric slave cylinder air bleeder, insert a vinyl hose in the pl ...

Manifold Absolute Pressure Sensor (MAPS) Specification
Pressure [kPa (kgf/cm², psi)] Output Voltage (V) 20.0 (0.20, 2.9) 0.79 46.7 (0.47, 6.77) 1.84 101.3 (1.03, 14.7) 4.0 ...

Delivery Pipe Installation
1. Install in the reverse order of removal. Delivery pipe installation bolt: 18.6 ~ 23.5 N.m (1.9 ~ 2.4 kgf.m, 13.7 ~ 17.4 lb-ft) ...

Copyright © www.kifomanual.com 2014-2025