Kia Forte: Parking Assist Sensor Installation - Parking Assist System - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Parking Assist Sensor Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Parking Assist System / Parking Assist Sensor Installation

1.
Install the ultrasonic sensor after connecting the connector.
2.
Install the front/rear bumper.
3.
Connect the negative (-) battery terminal.
Parking Assist Sensor Removal
[Front Bumper] 1. Disconnect the negative (-) battery terminal. 2. Remove the front bumper cover. (Refer to Body - "Front Bumpe ...

Parking Assist System Switch Removal
1. Disconnect the negative (-) battery terminal. 2. Remove the floor console assembly. (Refer to Body - "Floor Console Assembly&quo ...

See also:

Outside lamp
4 Door, 2Door 1. Open the trunk lid. 2. Remove the service cover by pulling out the service cover. 5 Door 1. Turn off the engine. 2. Open the tailgate. 3. Loosen the light assembly retai ...

ETC (Electronic Throttle Control) System Removal
1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Remove the resonator and the air intake hose (Refer to †...

Front Seat Shield Outer Cover Component Location
1. Front seat shield outer cover ...

Copyright © www.kifomanual.com 2014-2026