Kia Forte: Parking Assist System Switch Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / Parking Assist System / Parking Assist System Switch Removal

1.	Disconnect the negative (-) battery terminal.

2.	Remove the floor console assembly. (Refer to Body - "Floor Console Assembly")

3.	Disconnect the switch connectors (A).

4.	Remove the switchs (A) from the console upper cover.

Parking Assist Sensor Installation

1. Install the ultrasonic sensor after connecting the connector. 2. Install the front/rear bumper. 3. Connect t ...

Parking Assist System Switch Installation

1. Install the switchs and connect the switch connectors. 2. Insatll the floor console assembly. 3. Connect the ...

See also:

General Inspection
After or before servicing the EPS system, perform the troubleshooting and test procedure as follows. Compare the system condition with normal condition in the table below and if abnormal symp ...

Transaxle Control Module (TCM) Inspection
Transaxle Control Module(TCM) Problem Inspection Procedure 1. TEST TCM GROUND CIRCUIT: Measure resistance between TCM and chassis ground using the backside of TCM harne ...

Rear Seat Assembly Component Location
(4Door, 2Door) 1. Rear seat cushion assembly 2. Rear seat back assembly (5Door) 1. Rear seat back assembly [LH] 2. Rear seat back ...

Categories

Copyright � www.kifomanual.com 2014-2026