1. |
Disconnect the negative(-) battery terminal.
|
2. |
Remove the front door quadrant inner cover (A).
|
3. |
Disconnect the outside rear view mirror connector (A).
|
4. |
Verify that the mirror operates properly as shown in the table.
[Actuator]
Mirror Heater
Turn Signal Lamp
Puddle Lamp
Folding Mirror
|
IMS Power Seat Control Inspection
1.
Disconnect the IMS control switch connector.
2.
With the power IMS control switch in each position, make sure
that continuity ex ...
Audio Unit Installation
1.
Connect the audio unit connectors and cables.
2.
Install the audio unit.
3.
Install the center fascia panel ...
Output Speed Sensor Signal Waveform
Fig 1) Input/Output speed sensor at low speed
Fig 2) Input/Output speed sensor at high speed ...