1. |
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat switch.
A : Power seat control switch
B : Lumbar support switch
|
ETC (Electronic Throttle Control) System Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the resonator and the air intake hose (Refer to “I ...
Fuel Tank Air Filter Installation
•
Install the component with the specified torques.
•
...
Adjustment
Concentric Slave Cylinder Air Bleeding
Procedure
1.
After disconnecting a cap from the concentric slave cylinder air
bleeder, insert a vinyl hose in the pl ...