(4Door, 5Door) |
1. |
Remove the hole plug (B).
|
2. |
After loosening the mounting bolt, then remove the rear door outside
handle cover (A).
|
3. |
Remove the rear door outside handle (A) by sliding it rearward.
|
4. |
Install in the reverse order of removal.
|
Cylinder Head Inspection
Cylinder Head
1.
Inspect for flatness.
Using a precision straight edge and feeler gauge, measure the
contacting surface of the cylinder block and the ma ...
Output Speed Sensor Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Multimedia Jack Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the floor console assembly.
(Refer to Body - "Floor Console Assembly&quo ...