Kia Forte: Rear Oil Seal Installation - Cylinder Block - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Rear Oil Seal Installation

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cylinder Block / Rear Oil Seal Installation

1.
Install a new rear oil seal.
(1)
Apply engine oil on the edge of new oil seal.
(2)
Using SST (09231-H1100, 09214-2E000) and a hammer, tap in the oil seal (A) until the SST face is aligned with the cylinder block assembly rear face.

2.
Install the other parts reverse order of removal.
Rear Oil Seal Removal
1. Remove the automatic transaxle. (Refer to Automatic Transaxle System - "Automatic Transaxle") Remove the manual transaxle. (Refer to Manual ...

Piston and Connecting Rod Components
1. Piston ring 2. Snap ring 3. Piston pin 4. Piston 5. Connecting rod 6. Connecting rod upper bearing 7. Connecting rod lower bearing 8. Connecting rod bearing cap ...

See also:

Speakers Inspection
1. Troubleshooting for Speaker (1) Basic inspection of speaker Inspect the sound from speaker after verifying that the s ...

Under Body
Projected Dimensions * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Actual-Measurement Dimensions ...

Purge Control Solenoid Valve (PCSV) Inspection
1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV termi ...

Copyright © www.kifomanual.com 2014-2024