Kia Forte: Piston and Connecting Rod Components - Cylinder Block - Engine Mechanical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Piston and Connecting Rod Components

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Engine Mechanical System / Cylinder Block / Piston and Connecting Rod Components

1. Piston ring
2. Snap ring
3. Piston pin
4. Piston
5. Connecting rod
6. Connecting rod upper bearing
7. Connecting rod lower bearing
8. Connecting rod bearing cap

Rear Oil Seal Installation
1. Install a new rear oil seal. (1) Apply engine oil on the edge of new oil seal. (2) ...

Piston and Connecting Rod Disassembly
Engine removal is required for this procedure.    • Use fender covers to avoid damaging painte ...

See also:

Components Operations
ECM (Engine Control Module) 1. The ECM(PCM) (A) carries out a check of the ignition key using a special encryption algorithm, which is programmed into the transponder ...

Rear Wheel Speed Sensor Removal
1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) ...

If you have a flat tire (If equipped)
Jack and tools The spare tire, jack, jack handle and wheel lug nut wrench are stored in the luggage compartment. Remove the luggage under tray out of the way to reach the equipment. (1) Jack h ...

Copyright © www.kifomanual.com 2014-2025