Kia Forte: Rear Shock Absorber Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Suspension System / Rear Suspension System / Rear Shock Absorber Inspection
| 1. |
Check the rubber parts for wear and deterioration.
|
| 2. |
Compress and extend the piston rod (A) and check that there is
no abnormal resistance or unusual sound during operation.
|
Disposal
| 1. |
Fully extend the piston rod.
|
| 2. |
Drill a hole on the (A) section to remove gas from the cylinder.
|
Rear Shock Absorber Replacement
1.
Loosen the wheel nuts slightly. Raise the vehicle, and make sure
it is securely supported.
2.
Remove the front wheel and tire (A) from f ...
Rear Coil Spring Components
1. Spring upper pad
2. Spring
3. Spring lower pad
...
See also:
Cooling Fan Inspection
Fan Motor
1.
Disconnect the fan motor connector from the resistor.
2.
Connect the battery voltage to the "+" terminal and ...
Input Speed Sensor Specifications
▷ Type: Hall effect sensor
Operation condition [°C(°F)]
((-)40 ~ 150)) -40 ~ 302
Air gap(mm)in.
(1.2 ~ 1.8)
0.0472 ~ 0.0709
Output voltage ...
DC/DC Converter Removal
1.
Disconnect the battery negative (-) cable.
2.
Remove the crash pad lower panel.
(Refer to Body - Crash pad lower panel.)
...
Copyright © www.kifomanual.com 2014-2025