1. |
Remove the rear wheel & tire.
|
2. |
Release the parking brake lever and parking brake cable is loose.
|
3. |
Remove the parking brake cable (A), after removing the clip (B).
|
4. |
Remove the hose eyebolt (C).
|
5. |
Loosen the caliper mounting bolts (B), then remove the rear caliper
assembly (A).
|
6. |
Remove the rear brake disc by loosening the screws (A).
|
IMS Control Switch Inspection
1.
With the power seat switch in each position, make sure that continuity
exists between the terminals below. If continuity is not as specified,
replace the power seat ...
Inspection
1.
Disconnect the ignition switch connector (B) and key warning switch
connector (A) from the steering column.
2.
Check for continu ...
General
1.
Basically, all measurements in this manual are taken with a tracking
gauge.
2.
When a measuring tape is used, check to be sure there is ...