Kia Forte: Removal - BCM (Body Control Module) - Body Electrical System - Kia Forte TD 2014-2018 Service ManualKia Forte: Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Body Electrical System / BCM (Body Control Module) / Removal

1.
Disconnect the negative (-) battery terminal.
2.
Remove the heater & A/C control unit.
(Refer to Heating,Ventilation, Air Conditioning - "Heater & A/C controller unit(Manual))
(Refer to Heating,Ventilation, Air Conditioning - "Heater & A/C controller unit(DATC))
3.
Remove the floor console assembly.
4.
Remove the center lower cover (A) after loosening the screws.

5.
Remove the BCM unit. (in the order as below)
(1)
Disconnect the connectors (A) from the BCM unit.
(2)
Loosen the mounting nuts (B).
(3)
Remove the BCM unit (D) after disconnecting the connector (C) from the BCM unit.

Function
Function Description Input Output Front Washer & Wiper - IGN2 On & WasherS/W On and Off ...

Installation
1. Install the BCM unit. 2. Install the center lower cover. 3. Install the floor console assembly. ...

See also:

DC/DC Converter Removal
1. Disconnect the battery negative (-) cable. 2. Remove the crash pad lower panel. (Refer to Body - Crash pad lower panel.) ...

Fuel Tank Pressure Sensor (FTPS) Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge control solen ...

Specification
Item Type Watt (W) Head lamp Low STD H11 55 HID D8S 25 High H1 55 Turn ...

Copyright � www.kifomanual.com 2014-2026