Kia Forte: Installation

1.	Remove ignition key from the vehicle.

2.	Disconnect the negative (-) cable from battery and wait for at least thirty seconds.

Install the emergency fastening device with a bolt (B).

Tightening torque :

39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.9 ~ 39.8 lb-ft)

4.	Connect the emergency fastening device connector (A).

5.	Install the center pillar trim. (Refer to Body - "Center pillar trim")

6.	Install the door scuff trim. (Refer to Body - "Door scuff trim")

Insert the seat belt to the emergency fastening device.

Make sure the lock pin is connected in properly.

8.	Reconnect the battery negative cable.

After installing the emergency fastening device, confirm proper system operation:

A.	Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

1. Disconnect the battery negative cable, and wait for at least thirty seconds before beginning work. 2. Remove the seat belt after pushin ...

...

Categories