Kia Forte: Installation
| 1. |
Install the key lock cylinder.
|
| 2. |
Install the key warning switch and key Illumination.
|
| 3. |
Install the key warning/immobilizer connector.
|
| 4. |
Connect the ignition switch connector after Install the ignition
switch.
|
| 5. |
Install the wiper switch.
|
| 6. |
Install the steering column shrouds.
|
| 7. |
Install the driver crash pad lower panel.
|
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Low Panal")
...
Inspection
1.
Disconnect the ignition switch connector (B) and key warning switch
connector (A) from the steering column.
2.
Check for continu ...
See also:
Sunroof Switch Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the overhead console lamp assembly (A) after loosening
2 screws.
...
Room lamp
To turn the room lamp ON or OFF, push the switch.
If your vehicle is not equipped with a map lamp, the room lamp will also turn
on or off as follows.
The room lamp comes on when a door is opene ...
Rear Body
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Side outer p ...
Copyright © www.kifomanual.com 2014-2025