1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the smart junction box
(Refer to Body Electrical System - "Relay Box (Passenger Compartment)")
|
3. |
Disconnect clutch switch connector (A).
|
4. |
Remove the clutch switch (B) by loosening a nut (A).
|
Power Door Lock Actuators Inspection
Front Door Lock Module Inspection
1.
Remove the front door trim.
(Refer to Body - "Front Door Trim")
2.
Remove the front d ...
Intake Actuator Description
The intake actuator is located at the blower unit. It regulates the intake
door by the signal from the control unit. Pressing the intake selection switch
will shift between recirculation and ...
Installation
1.
Install in the reverse order of removal.
2.
Adjust the ignition lock switch.
(1)
In state of full stro ...