Kia Forte: Shift Lever Inspection
Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Manual Transaxle System / Manual Transaxle Control System / Shift Lever Inspection
| 1. |
Check operating of lever of T/M side when operating shift lever
after assembly.
|
| 2. |
When shift lever to "R" position, check the position of "skirt".
|
| 3. |
When lever is shifted to each position, if stop occur between
two position, re-adjust select cable.
(Refer to Control cable - "Adjustment")
|
Shift Lever Installation
1.
Install in the reverse order of removal.
•
...
Control Cable Components
1. Shift lever knob
2. Shift lever assembly
3. Shift cable assembly
4. Select cable assembly
5. Retainer
...
See also:
Inspection
If any of the following conditions occur, WCS reset and accuracy check
should be performed.
•
The WCS ECU or any of the sensors is replaced.
•
...
35R Clutch Control Solenoid Valve(35R/C_VFS) Removal
Replacing an on/off solenoid valve (SS-A, SS-B) does not require
additional hydraulic pressure adjustment; however, the ...
Mode Control Actuator Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the mode control
actuator based on the signal of the A/C control unit. Pressing ...
Categories
- Home
- Kia Forte BD 2019-2026 Owners Manual
- Kia Forte BD 2019-2026 Service Manual
- First Generation
- Second generation
- Kia Forte TD 2014-2018 Owners Manual
- Kia Forte TD 2014-2018 Service Manual
Copyright www.kifomanual.com 2014-2026