Kia Forte: Shift Lever Removal - Automatic Transaxle Control System - Automatic Transaxle System - Kia Forte TD 2014-2018 Service ManualKia Forte: Shift Lever Removal

Second generation YD (2014-2018) / Kia Forte TD 2014-2018 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Shift Lever Removal

1.
Remove the floor console assembly.
(Refer to Body - "Floor Console")
2.
Remove the air duct.
3.
Disconnect the control cable (A).

4.
Disconnect the connector (A).
5.
Disconnect the wire mounting clips (B).
6.
Remove the bolts and then shift lever assembly (A).

Tightening torque:
8.8 ~ 13.7N.m(0.9 ~ 1.4kgf.m, 6.5 ~ 10.1lb-ft)

Shift Lever Components
1. Shift lever knob 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...

Shift Lever Installation
1. Install in the reverse order of removal.    Install the cable after placi ...

See also:

Photo Sensor Description
The photo sensor is located at the center of the defrost nozzle. The photo sensor contains a photovoltaic (sensitive to sunlight) diode. The solar radiation received by its light receiving p ...

Installation
1. Install in the reverse order of removal. 2. Tighten the vacuum pump mounting bolts to the specified torque. ...

SS-A Solenoid Valve(ON/OFF) Description
Shift Solenoid(SS) Valve-A is attached to the valve body and is an on/off solenoid valve that is used to change gears. Shift Solenoid(SS) Valve-A is installed at valve body. ...

Copyright © www.kifomanual.com 2014-2025