Kia Forte: Side Body
| * These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ] |
|
|
|
|
| Front side member tooling hole (Ø12) |
Fender apron upper member tooling hole (Ø9) |
Front door upper hinge mounting hole
(Ø13) |
|
|
|
|
| Front door lower hinge mounting hole
(Ø13) |
Side outer panel notch |
Side outer panel notch |
|
|
|
|
| Side outer panel notch |
Side outer panel notch |
Front door switch mounting hole (Ø10) |
|
|
|
|
| Quarter fixed garnish notch |
Quarter fixed garnish tooling hole (Ø5) |
Quarter fixed garnish notch |
|
|
||
| Rear bumper mounting hole (8.5X8.5) |
Front Body
Front Body A
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Front Body B
* These dimensions indicated in th ...
Interior
Interior A
* These dimensions indicated in this figure are
actual-measurement dimensions. [ Unit : mm (inch) ]
Interior B
* These dimens ...
See also:
Accelerator Position Sensor (APS) Description
Accelerator Position Sensor (APS) is installed on the accelerator pedal
module and detects the rotation angle of the accelerator pedal. The APS is one
of the most important sensors in engine ...
Control Cable Removal
1.
Remove the floor console assembly.
(Refer to Body - " Floor Console")
2.
Remove the select cable (B) by removing the snap ...
SRS Control Module (SRSCM)
The primary purpose of the SRSCM (Supplemental Restraints System Control
Module) is to discriminate between an event that warrants restraint system deployment
and an event that does not. The ...
Copyright © www.kifomanual.com 2014-2024